The appearance of advertisements and product information on this site does not constitute an endorsement by Equipment World Magazine, and Equipment World Magazine has not investigated the claims made by any advertiser. Product information is based solely on material received from suppliers.

Hobart Welding Products Plasma Cutter
April 7, 2010

Using only compressed air for fuel, Hobart Welding Products‘ rugged 60-lb. AirForce 625 Plasma Cutter produces cut quality when cutting at a rate of 10 inches per minute (IPM) on 1/2-in. steel using a hand-held torch. It can sever steel up to 7/8-in. thick and slices through thinner metals at amazing rates: 1/4-in. steel at more than 60 IPM and 1/8-in. steel at 200 IPM.  Because of its power, portability and cut quality, the AirForce 625 provides great versatility for light construction, maintenance and fabrication. The AirForce 625 finishes cuts more cleanly. Rather than being susceptible to the voltage drops that normally occur at the very end of the cut, it maintains power to cleanly sever the last piece of metal.