- Equipment World - http://www.equipmentworld.com -
Zanetis Power introduces new series of milling attachments
Posted By Equipment World Staff On December 2, 2009 @ 10:04 am In Boomerang | No Comments
( Brownsburg, In.) Zanetis Power Attachments has launched a new series of self
powered milling attachments for loader backhoes and wheel loaders.
This attachment is ideal for milling asphalt or concrete prior to overlay, cutting utility
trenches and performing in place recycling or stabilization of road base and soil.
The key to the new series (called the “RoadHog”) is that they are completely self
contained with their own engine and hydraulic system, which eliminates any power
requirements from the host vehicle.
The RoadHogs are powered by John Deere PowerTech turbocharged Tier 3 compliant
4 cylinder diesel engines. The 76hp unit is suitable for backhoes over 13,000lbs. The
140 and 200hp unit is designed for wheel loaders with a minimum of 12,000lbs. of static
tip load at full turn. Power is transferred through a hydraulic clutch to a planetary gear
driveline within the drum.
The 76hp units, available in 30 and 40 cutting widths, feature an 8” cutting depth
capability. The 140 and 200hp units for wheel loaders have a cutting depth of 12” with
cutting widths of 40, 48, 60 and 72 inches. The cutting drum can be sideshifted
hydraulically to the operator’s right side for cutting shoulders or against curbs. The unit is
also equipped with hydraulic tilt (slope) control for matching grade or making bevel cuts.
Other options include an assortment of cutting drums and an 80 gallon pressurized
In addition, they feature a wireless remote controller that activates engine functions as
well as hydraulic tilt, depth and sideshift control of the drum, backed up by a master
instrument control panel. The master control panel also controls the drum position and
monitors engine functions, including fuel consumption and diagnostic codes, and can be
programmed to remind the operator of upcoming engine service intervals.
The unit is attached to the loader in place of the bucket using of pin on style or quick
attach style brackets, increasing loader versatility within the owner’s fleet.
This attachment is well suited for municipalities as well as paving and utility contractors,
as it has a much lower cost than dedicated milling machines and delivers higher
horsepower than skidsteer based planers.
The Zanetis Group has over 40 years of combined experience in the design,
manufacture and distribution of milling attachments, with distributors in the U.S. and
abroad, including Europe and the Pacific Rim.
Article printed from Equipment World: http://www.equipmentworld.com
URL to article: http://www.equipmentworld.com/zanetis-power-introduces-new-series-of-milling-attachments/
Copyright © 2012 Equipment World -- Development. All rights reserved.