- Equipment World - http://www.equipmentworld.com -
Posted By admin On March 1, 2012 @ 6:00 am In In the Magazine | No Comments
Never bypass a machine’s safety features
By Amy Materson
The accident: Using a borrowed compactor, an operator was compacting soil for a new road. The machine had a faulty starter system – when used on rough terrain, the engine would die, requiring a manual jump start. When the machine died yet again, the operator tried to jump start the engine with a hand tool; however, the machine was in high gear and the propulsion lever was full forward. The machine moved forward when the operator leaned over the tire, pulling him between the tire and fender assembly, crushing and killing him.
The bottom line: A post-accident investigation determined the machine had difficulty starting all day. To restart the machine, the operator had to stand on the rim of the left wheel assembly, reach across the tire and use a 7/16-3/8-inch offset open end wrench to jump across the starter solenoid terminals. Both the guard over the side of the engine where the solenoid was located and the operator’s manual were missing. The general contractor stated he did not know the machine was malfunctioning.
A number of mistakes were made that led to this worker’s death. When using compaction equipment, remember the following:
Don’t use defective equipment. Inspect your equipment prior to use. If you find a malfunction, let your supervisor know so the machine can be placed out of service until repairs can be made.
Respect the machine’s safety features. During your inspection, ensure safety features are operational, and comply with all warning labels. Never bypass equipment safety features to start or run a machine. Know ahead of time what procedures are in place in the event of equipment malfunction.
Follow proper procedures, especially during a malfunction. Although the compactor’s manufacturer didn’t recommend jump starting the machine in every instance, the operator’s manual – which was missing in this instance – outlined an acceptable procedure. Had the manual been in the machine, the operator would have had access to the correct information, which directed setting the propulsion lever and parking brake to prevent movement upon ignition.
 Information for this Safety Watch is from an accident report and the Occupational Safety and Health Administration’s NIOSH Fatality Assessment and Control Evaluation Program. It is meant for general information only.
Article printed from Equipment World: http://www.equipmentworld.com
URL to article: http://www.equipmentworld.com/safety-watch-23/
URLs in this post:
 Image: http://www.equipmentworld.com/files/2012/02/safetyUntitled-1.jpg
 Image: http://www.equipmentworld.com/files/2012/02/we-careUntitled-1.jpg
 Image: http://www.equipmentworld.com/files/2012/02/bridgestoneUntitled-1.jpg
Copyright © 2012 Equipment World -- Development. All rights reserved.