- Equipment World - http://www.equipmentworld.com -
GCS600 Grade Control System Cross-Slope and Elevation Control
Posted By admin On February 18, 2009 @ 12:00 am In Boomerang | No Comments
The GCS600 Grade Control System is a highly flexible, cross slope and elevation control system designed to be used on motor graders for fine grading work. The GCS600 uses two AS400 angle sensors and one RS400 rotational sensor to calculate the cross slope of either side of the blade, as well as an LR410 laser receiver or an ST400 Sonic Tracer to provide elevation control. Using the ST300, the system allows stringline, previous pass, or curb and gutter tracing. Using one or two LR410 laser receivers, you can use the system for fine grading plane surfaces. The GCS600 system is ideal for applications with tight tolerances and finished grade work.
When you use the CB420 Control Box with the GCS600, you get software with a powerful range of features specifically designed for lift and/or tilt control on dozers and motor graders.
The GCS600 can be purchased either as a GCS600 system or as an upgrade from the GCS500 Grade Control System.
Article printed from Equipment World: http://www.equipmentworld.com
URL to article: http://www.equipmentworld.com/gcs-grade-control-system-crossslope-and-elevation-control/
Copyright © 2012 Equipment World -- Development. All rights reserved.