The appearance of advertisements and product information on this site does not constitute an endorsement by Equipment World Magazine, and Equipment World Magazine has not investigated the claims made by any advertiser. Product information is based solely on material received from suppliers.

Magnum Mfg. MAG2000X
October 13, 2008

The Magnum MAG2000X torch system can cut, gouge or pierce any material in seconds for a variety of work benefits using fin wrapped flame tubes. Effect emergency repairs, routine maintenance or salvage with the same torch. Use an arc rod to get incredibly long cuts. The arc rods last up to 20 minutes of continuous cutting on land, and several minutes of cutting in underwater settings. Set is straight forward and takes approximately five minutes. Hook the oxygen hose to the regulator and the regulator to a CGA 540 bottle. Connect the cable to a D.C. welder if arc mode is desired. Insert a flame tube or arc rod and you are ready to begin cutting. Divers can now forget material barriers. Flame tubes can cut through rust, scale, paint, slag, concrete linings, barnacles and more.